Project Description

CD 2S-4 – Fiber Opener

This fibre fine-opener is particularly suitable for staple fibre, but it can process all types of short fibre (wool, cotton, waste, etc.)

The machine consists of four turbines in sequence. The first two stages are driven by a common motor, while the third and fourth stage are driven by individual motors. The speed of all motors can be adjusted from 2,400 to 3,800 rpm through inverters.

The width of the turbine housings can be adjusted in order to adapt the machine to the length and type of fibre to be processed.

The infeed hopper has an inbuilt protection against hand contact with the turbine wheel.

The machine can be fully integrated into a production line and switched on/off by linking it to up- or downstream equipment such as our AB 450N bale breaker or our M 1P blender.

Electrical system housed in an IP66 standard cabinet equipped with a disconnector switch, motor protections, inverter, magnetic disconnector switches on turbine housing and low voltage controls.

The machine is built according to the requirements of the European Directives 2006/42/CE, 2004/108/CE e 2006/95/CE and subsequent amendments. The machine duly bears the CE marking

Technical data:

Capacity: 450kg/h (approximately)
Width: 125cm
Length: 260cm
Height: 135cm (without infeed hopper)
Weight: 250kg
Power absorption: 3 three-phase motors with 10,0kW total absorption

Figures, descriptions and technical data are non-binding and can be subject to change without notice.